How are you supposed to move a 5m + Ski?

General offshore yakking discussion.
User avatar
4liters
PHD in Yakology.
Posts: 2119
Joined: 02 Jun 2015, 10:55
kayak: Native Watercraft Slayer 13, Stealth Fisha 500
Real Name: Ian

Re: How are you supposed to move a 5m + Ski?

Post by 4liters »

4liters wrote:
Seasherpa wrote:
cheaterparts wrote:
Ian - Eoin had a rack bar made that clips onto the sides of the bonnet to support the skis on long trips , it may also be worth a look at - someone over his side of the world Fabbed it up out of aluminium

http://www.vyak.net/forum/viewtopic.php ... 0&start=90

or most bull bars and or nudge bar bolt onto the bumper iron mounts of cause most new cars dont run bumper irons and in fact most front wheel drive dont have a lot of structural points forward of the engine - just enough to hold a radiator and some plastic

There can also be issues with things bolted onto the front setting off airbags too apparently which is why I went with the bonnet option, but since then commercial options have come available for carrying outrigger canoes which might also work:
https://www.ebay.com.au/itm/Ruk-Sport-K ... 2531863028
How do those things work?
Never mind, I can see all the pictures now I'm not on the phone.

Looks like a purpose built version of the ladder I was planning on using, it also looks like it should be relatively straightforward to lengthen by cutting and sticking an insert in the middle.

I think the kayak would need to sit on an angle in the racks because it would be too wide at those points to lie flat but I don't think that would cause any problems.
craigcole10
Apprentice
Posts: 42
Joined: 25 Feb 2020, 20:23
kayak: Feelfree Moken 12.5v2
Real Name: Craig
Location: Cheltenham

Re: How are you supposed to move a 5m + Ski?

Post by craigcole10 »

Digging this one up from the vyak vault as I'm soon to push the button on a PF525 and wondering how everyone overcame the overhang issue at the front when car topping long kayaks.

I'm about to have delivered a Ford Everest and from what I can see when keeping to the 60% of wheelbase rule there will be a significant amount at the front of the kayak that will not be supported. As it's a new car I'm not keen on doing something like what Eoin had made at the front, instead would rather have a frame to sit on the roof rails to attach cradles/lock rack, similar to what Cheater suggested below. Has any one bought or had one made to resolve the issue?
cheaterparts wrote: 09 Sep 2019, 11:22
Just looking at these another option may be to make a light beam ( sq tube ) with a pair of cross beams to fit lock rack

This could clamp to see roof racks with maybe some form of support at the end Might be worth thinking about
As most of my fishing would be within an hours drive (subject to being released) is this something I don't need to worry about unless I'm going further a field.

Cheers

Craig
User avatar
Reeling
Lord of the fish
Posts: 1090
Joined: 22 Nov 2016, 20:20
kayak: Stealth PF 525
Real Name: Nath
Location: Altona

Re: How are you supposed to move a 5m + Ski?

Post by Reeling »

Firstly good luck roof topping a 525 onto an Everest!

I've had a PF525 on a Focus and now a Focus wagon without a problem. You'll just have to find where the kayak sits fore/aft between the roof bars. The front end of the everest is practically the same as the Ranger so the roof bar locations are probably the same. Frank used to transport his PF525 on his Ranger with just the two standard bars

I find that most journeys are ok with just roof bar straps, but if running longer journeys I tend to put a front strap to stop the kayak from lifting.

Always good to put a hi-viz sock or similar on the stern to at least show any glancing policemen/women that you're doing your best.
Tuna 20.5kg ---KingFish 90cm --- Snapper 84cm --- Gummy 83cm (55cm legal) ---- Whiting 40cm --- Silver Trevelly 41cm --- Flathead 52cm --- Aussie Salmon 38cm --- Squid 34cm hood

Facebook Page Reeling Fish
Instagram Page Reeling Fish
craigcole10
Apprentice
Posts: 42
Joined: 25 Feb 2020, 20:23
kayak: Feelfree Moken 12.5v2
Real Name: Craig
Location: Cheltenham

Re: How are you supposed to move a 5m + Ski?

Post by craigcole10 »

Thanks Reeling. I'm currently car topping a 38kg kayak onto a Nissan murano and everest is only 100mm higher so it'll probably be similar on the pain in the arse scale to what I'm doing now.

The focus wagon looks similar to the everest in terms of the front rail distance from the rear of the car so you must be running a good sized overhang off the front or are you pushing the rear overhang out slightly. Up until last week I was intending to get a 475 due to garage space so front overhang would be manageable but now the extra 500mm throws it out a fair bit.
User avatar
Reeling
Lord of the fish
Posts: 1090
Joined: 22 Nov 2016, 20:20
kayak: Stealth PF 525
Real Name: Nath
Location: Altona

Re: How are you supposed to move a 5m + Ski?

Post by Reeling »

Ye you'll enjoy it being lighter, thats for sure. What you may notice though is the extra 1.5m length catches the wind a bit when you are lifting it onto the roof.

Ye i think the focus wagon is on boardline. The PF525 is balanced pretty well on my roof rack when the bow is about level with the front of the car - so legally as far forward as it can be. I think this means the stern is around that 60% mark - plus or minus.

I dont think its looks drastic because, being a wagon, it has a fair bit of body overhang rearward of the rear axle, whereas compared to a hatchback, the rear body overhang is less. Anotherwords, comparing a hatch and wagon with the same wheelbase, the wagon will have less kayak hanging out the back in "free air" and inherently look better.

EDIT: Focus wagon and Hatch have wheelbase of 2700mm, but wagon has 282mm extra rear overhang
Tuna 20.5kg ---KingFish 90cm --- Snapper 84cm --- Gummy 83cm (55cm legal) ---- Whiting 40cm --- Silver Trevelly 41cm --- Flathead 52cm --- Aussie Salmon 38cm --- Squid 34cm hood

Facebook Page Reeling Fish
Instagram Page Reeling Fish
Post Reply