Page 1 of 1

DIY yak trolley

Posted: 09 Dec 2017, 13:07
by watermullon
Hey all,

Thought I'd share my yak trolley project.

I wasn't going to do a trolley just yet, but I had second thoughts after I noticed the weight of my yak (perception pescador 13) after all my gear was on it.
So I whipped up a yak trolley yesterday with gear from Bunnings. Works a treat (on grass anyway.)

The gear: The make:
Just measure out the width of your holes in your yak, and the depth to the keel. Add a bit extra for the width of the pool noodle and cut it all up. I had to enlarge the holes in the noodles, but that isn't hard.
Put the steel rod through the pvc pipe at the bottom, cut to size and drill to put a pin in each end to keep it all together.
The only part I have glued is the middle pvc bar that the keel rests on. The rest can come apart and stays together with the pressure of the yak on it.
The PVC part that goes inside the yak is slightly thinner PVC (20mm), and goes down inside the pressure pipe almost to the wheels. I put a bolt through to hold it in place at the length I needed.

I know I know don't re-invent the wheel ... but why should the wheel guy inventor be the only one who has all the fun?
Besides ... customised to fit my yak perfectly and the satisfaction of DIY.

and the finished product in action:

Image
Image
Image
https://www.dropbox.com/s/86dchr529n6fi ... 1.jpg?dl=0
https://www.dropbox.com/s/uzdf49jk1trzf ... 1.jpg?dl=0
https://www.dropbox.com/s/cuzny4hp0n4az ... 9.jpg?dl=0

... now for the test on the beach and mud. Hope I don't need to buy bigger wheels ...

Re: DIY yak trolley

Posted: 09 Dec 2017, 14:29
by chrisw
Those wheels may have problems in soft sand (though to be fair pretty much all do bar custom sand wheels).

This thread is worth checking for sand-friendly modifications.

Re: DIY yak trolley

Posted: 09 Dec 2017, 14:38
by peatop
Yah green machine wheels from k mart work well in soft sand once you put a couple of layers of expansion joint foam on them $8 each and around $15 for the foam and some glue like kwik grip you can buy a foam mat from k mart also bout $8 this will do both wheels and have some left over.

Re: DIY yak trolley

Posted: 01 Jan 2018, 11:51
by jaybird01
1.jpg
Along the same lines this is the one I made for my Outback, the 2 white pipes fit into the rod holders and the kart is held on with 2 straps. It works well.