I made a double rod-holder for my Sport and Revo ages ago, so thought I'd have a go at a similar
model for the A.I.
All I wanted was a simple couple of tubes to carry the rods while not in use. So I just used a few
short lengths of 40mm PVC pipe, along with two 45 degree 40mm junctions, and a bit of that
horrible, blue PVC glue...
Here's the result:
Like the ones I made for my other yaks it slots into one of the the moulded-in rod-holders behind
the seat, and is a two-in-one holder.
The added complexity with the A.I. is that you have a sail and rope whipping around behind you
and it's always a risk that a rod will be flicked out the the holder by the sail. I did my best to
angle the holders to (hopefully!) prevent this, but time will tell. The rods are leashed,
but I'd prefer them not to be dunked!
Cheers,
Mike.